Furnace Repair in Tulia

Serving Tulia and every community across Swisher County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
A single-story brick house with a two-car garage and shingled roof under a heavy overcast sky, with rain falling, water streaming from the eaves, and a wet driveway in the foreground beside a large tree and lawn.

A furnace in Swisher County has been running against real load, and a contractor diagnosing a repair here starts by checking what that load has done to the heat exchanger, the limit switches, and the control board before drawing any conclusions about what failed and why. 137 severe weather events were recorded in Swisher County, Texas between 2015 and 2024. At that rate, severe weather is part of normal operating life for every system in this county, and components that sit between the burner and the rest of the house tend to show the wear first. A contractor who skips that check can quote the wrong repair.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Interior of a garage with concrete block walls and a closed sectional door, showing exposed galvanized sheet-metal ductwork and round ducts mounted under the wood joist ceiling, with a step ladder and a white bag on the floor.

Ductwork and wiring that has been patched across multiple heating systems over the decades is common in housing stock this old, and it shapes what a contractor finds once a furnace is open. Half the homes in Swisher County, Texas were built in 1961 or earlier (2020-2024 ACS 5-year). A unit running in a house built that long ago has often outlasted one or more of its own parts generations, and the question a contractor has to answer on the spot is whether what it needs is still being made. When a component turns out to be superseded, the repair either waits on a specialty supplier or the scope changes entirely.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

The Parts of a Furnace a Contractor Checks First

Isometric line illustration of a cutaway building interior showing a furnace unit with a flue pipe and ductwork running along the ceiling, plus adjacent rooms with simplified furniture.

The heat exchanger sits inside the furnace cabinet and is the piece a contractor looks at early in a repair call. Cracks or corrosion there let combustion gases into the airstream. The burners sit just below it and are where the fault shows up when the furnace lights poorly or not at all.

The blower motor sits at the base of the cabinet and pushes conditioned air into the supply ducts. Near it, the inducer motor pulls exhaust gases out through the flue before ignition begins. The flame sensor, a small rod that sits in the burner assembly, shuts the system down when it cannot confirm a flame is present and is a frequent repair point.

The drawing shows a general furnace layout, and a licensed contractor determines which components apply and what condition they are in for your specific system.

Find a contractor in Swisher County

Swisher County by the Numbers

137

137 severe weather events were recorded in Swisher County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1961

Half the homes in Swisher County, Texas were built in 1961 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
3,029

Swisher County, Texas holds 3,029 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
66.4%

Owners occupy 66.4% of the occupied homes in Swisher County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Codes & Standards Governing Furnace Repair in Swisher County, Texas5 sourced rules and standards

What Happens When the Contractor Arrives

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Swisher County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Swisher County

Extreme weather puts real stress on heating equipment, and how hard a furnace works over its lifetime is shaped by local conditions. Swisher County's weather record is part of what makes furnace repair here a local question, not a generic one.

Severe weather events by county — Swisher County
3020100
2015201620172018201920202021202220232024
23

137 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.