Furnace Installation in Alice

Serving Alice and every community across Jim Wells County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
View through a rain-streaked window with white trim looking out at a wind-blown leafy tree under an overcast sky, with a neighboring building's horizontal siding and roof edge at the right.

A contractor quoting a furnace installation in Jim Wells County starts from what the equipment has actually been up against. 47 severe weather events were recorded in Jim Wells County, Texas between 2015 and 2024. At that rate, severe weather has touched most systems here only rarely, which means age, original installation quality, and maintenance history carry far more weight in explaining what a furnace does and does not do. A contractor sizing and placing new equipment focuses on those local factors rather than treating weather load as the primary variable.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Unfinished attic with wooden rafters and plank floor, a foil-wrapped insulated duct running down the center, batts of insulation along both eaves, and two cardboard boxes at the far end.

Ductwork sized and routed for equipment generations removed from what a contractor installs today is the first thing that has to be assessed in a furnace job here. Half the homes in Jim Wells County, Texas were built in 1981 or earlier (2020-2024 ACS 5-year). That matters for installation because a new furnace has its own airflow and static pressure demands, and duct runs that predate those specs may move air wrong even when they are structurally intact. The electrical side warrants the same look. A contractor who checks both before quoting has what they need to give a number that holds.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Gets Installed With a New Furnace

Isometric cutaway illustration of a single-story house with a dark shingled roof, showing interior rooms with furniture and a furnace connected to ductwork and a flue pipe extending above the roof.

The furnace itself sits in a utility closet, basement, or attic and is the box that generates heat. Inside it, a burner assembly fires the fuel, a heat exchanger transfers the warmth to moving air, and a blower motor pushes that air out into the house. A flue pipe runs from the furnace to an exterior wall or roofline and carries combustion gases out.

The air handler cabinet connects to the supply and return sides of your duct system, so treated air can move through every room. Alongside the furnace, a contractor installs a thermostat on an interior wall to control when the system runs, and a fresh filter housing sits at the return-air opening to protect the blower and heat exchanger from debris.

The drawing shows a typical layout, and a licensed contractor determines exactly what applies to this house.

Get matched in Jim Wells County

Jim Wells County, by the numbers

47

47 severe weather events were recorded in Jim Wells County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1981

Half the homes in Jim Wells County, Texas were built in 1981 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
16,229

Jim Wells County, Texas holds 16,229 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
68.5%

Owners occupy 68.5% of the occupied homes in Jim Wells County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Furnace Installation Rules & Standards for Jim Wells County, Texas5 codes, laws, and standards

What the Installation Looks Like in Jim Wells County

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Jim Wells County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather History in Jim Wells County

Weather in Jim Wells County puts real stress on heating and cooling equipment, and that stress shapes what a furnace has to handle year after year. Understanding the local pattern is part of sizing and installing equipment that holds up under actual conditions here.

Severe weather events by county — Jim Wells County
86420
2015201620172018201920202021202220232024
8

47 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.