Furnace Installation in New Braunfels

Serving New Braunfels and every community across Comal County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
View through a rain-streaked double-hung window with dark interior trim, showing a leafy tree, overcast sky, and the horizontal siding and roof edge of an adjacent building.

A furnace installation in Comal County carries a sizing question that catalog specs alone do not settle. 111 severe weather events were recorded in Comal County, Texas between 2015 and 2024. At that rate, severe weather is a standing condition of operation here, and a contractor who ignores it when selecting equipment and sealing the system against the elements is leaving the homeowner exposed. A unit that passes a manufacturer's baseline test is not automatically right for a location where the heating system gets pushed hard with regularity. The install has to account for what this place actually demands.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Attic interior with wooden rafters, OSB board flooring, loose fiberglass insulation along the eaves, two cardboard boxes, and a long gray flexible duct running across the floor.

Ductwork laid out for an older generation of equipment is the starting point every furnace installation here has to reckon with. Half the homes in Comal County, Texas were built in 2005 or earlier (2020-2024 ACS 5-year). That age of construction means the trunk lines, branch runs, and return paths in a typical house were engineered around systems that moved air differently than what a contractor installs today. If the existing layout cannot deliver balanced airflow for a new unit, the ductwork gets modified before the furnace itself matters much. An electrical service evaluation follows the same logic: what the house was wired to support and what the new equipment draws have to match before the job is done.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Gets Installed With a New Furnace

Isometric line illustration of a single-story house cutaway showing interior rooms with furniture, ductwork or piping running along the ceiling, and a boxy furnace unit with a tall vertical flue pipe.

The furnace itself sits in a utility room, basement, or closet and is the unit a homeowner sees when they look at the system. Inside it, a heat exchanger warms the air that moves through the house, and a blower fan pushes that air out. A burner assembly and an ignition component sit at the core of the unit.

A flue pipe runs from the furnace to an exterior wall or through the roof, carrying combustion gases out of the house. The air filter holder mounts at the return-air intake, and a thermostat goes on an interior wall where it reads the temperature of the living space and signals the furnace to run.

The drawing shows a typical layout, and a licensed contractor determines what applies to this specific house.

Get matched in Comal County

Comal County, by the numbers

111

111 severe weather events were recorded in Comal County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
2005

Half the homes in Comal County, Texas were built in 2005 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
77,961

Comal County, Texas holds 77,961 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
76.6%

Owners occupy 76.6% of the occupied homes in Comal County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Furnace Installation Rules & Standards for Comal County, Texas5 sourced codes and standards

What HVAC Installation Looks Like in Comal County

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Comal County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Comal County

Comal County weather puts real demands on heating equipment, and those demands shape what a furnace installation here needs to handle. A contractor sizing and installing for this area works from local conditions, not a generic baseline.

Severe weather events by county — Comal County
3020100
2015201620172018201920202021202220232024
22

111 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.