Furnace Installation in Mexia

Serving Mexia and every community across Limestone County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
Single-story brick house with a gray shingle roof, attached two-car garage with a beige door, and trimmed shrubs, seen during rain with a wet driveway in the foreground and overcast sky.

A furnace install in Limestone County is a sizing decision before it is anything else. 106 severe weather events were recorded in Limestone County, Texas between 2015 and 2024. At that rate, severe weather is a standing condition for equipment here, not an occasional stressor, and a furnace that is undersized for the actual load will run at the edge of its capacity through the seasons that matter most. A contractor quoting the job has to account for what the house will demand on the worst days, not the average ones. Get the sizing wrong and the unit works harder than it was built to, year after year.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Interior of a garage with painted concrete block walls, a sectional overhead door, and exposed galvanized rectangular and round ductwork suspended from the joisted ceiling, with a wooden step ladder and a filled sack on the concrete floor.

Ductwork laid in for an older furnace carries assumptions about airflow that a modern unit may not share. Half the homes in Limestone County, Texas were built in 1983 or earlier (2020-2024 ACS 5-year). That depth of vintage matters for installation because a contractor quoting a new furnace has to determine whether the existing trunk lines and branch runs will move air the way the replacement system requires, or whether the duct layout becomes part of the job. The electrical side follows the same logic: service panels in houses of that era were configured for loads that differ from what a current furnace draws. The equipment gets quoted last, after the house tells the contractor what it already has.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Gets Installed With a New Furnace

Isometric line illustration of a cutaway building interior showing a furnace unit with a flue pipe and ductwork running along the ceiling, plus adjacent rooms with simplified furniture.

The furnace itself sits inside the house, almost always in a utility room, basement, or closet. It holds the burner assembly, the heat exchanger, and the blower. The burner assembly is where fuel is burned, the heat exchanger is the metal chamber that transfers that heat to air, and the blower pushes conditioned air out into the home.

The flue pipe runs from the furnace to an exterior wall or through the roof, carrying combustion gases out of the house. Alongside the furnace, the air handler cabinet houses the blower motor and the filter rack, and the thermostat mounts on an interior wall and serves as the control point for the whole system.

The drawing shows a typical layout, and a licensed contractor determines exactly what applies to your house and its existing setup.

Find a contractor in Limestone County

Limestone County, by the numbers

106

106 severe weather events were recorded in Limestone County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1983

Half the homes in Limestone County, Texas were built in 1983 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
10,443

Limestone County, Texas holds 10,443 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
72.1%

Owners occupy 72.1% of the occupied homes in Limestone County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Furnace Installation Rules for Limestone County, Texas5 codes, standards & licensing rules

What the Installation Actually Looks Like

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Limestone County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Limestone County

Weather shapes how hard a furnace works and how long it lasts. The conditions recorded here are part of what any contractor sizes and installs for.

Severe weather events by county — Limestone County
20100
2015201620172018201920202021202220232024
19

106 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.