Furnace Installation in Longview

Serving Longview and every community across Gregg County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
View through a rain-streaked double-hung window in a dark interior frame, showing a green leafy tree, an overcast sky, and the horizontal lap siding of an adjacent building.

A furnace contractor quoting in Gregg County has to account for what the climate here actually demands before settling on equipment size, duct layout, or sealing method. 105 severe weather events were recorded in Gregg County, Texas between 2015 and 2024. At that rate, severe weather is a standing feature of operating here, which means a system installed to catalog specs rather than local conditions starts its service life behind. A contractor who knows the area sizes for the load this climate puts on heating equipment, not for what the spec sheet assumes.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Attic interior with wooden rafters, OSB board flooring, loose fiberglass insulation along the eaves, two cardboard boxes, and a long gray flexible duct running across the floor.

Ductwork sized and routed for older equipment does not automatically carry what a new furnace needs, and that gap is where a Gregg County installation gets decided. Half the homes in Gregg County, Texas were built in 1980 or earlier (2020-2024 ACS 5-year). A house that old was built around a different assumption about how air moves through it, and the trunk lines and branch runs reflect that. A contractor installing a furnace here measures the existing duct system against what the new unit will actually push through it, because undersized or poorly routed ductwork produces uneven heat no matter how capable the furnace itself is. The electrical service gets the same look, since load requirements have shifted across the decades that separate the wiring from the equipment going in.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Gets Installed With a New Furnace

Isometric cutaway illustration of a single-story house showing interior rooms with furniture, a furnace unit connected to ductwork and a tall flue pipe extending through the roof.

The furnace itself sits inside the home, most often in a utility room, basement, or closet, and it is the unit that produces heat. Beside or above it, the air handler moves conditioned air into the duct system. These two pieces are the core of what a contractor brings in and sets in place.

The flue pipe runs from the furnace through the wall or roof, carrying combustion gases out of the house. The thermostat mounts on an interior wall and serves as the control point for the whole system. A new gas line connection or electrical supply line ties into the furnace at the unit itself.

The drawing shows a typical layout, and a licensed contractor determines exactly what applies to your home's configuration.

Get matched in Gregg County

Gregg County, by the numbers

105

105 severe weather events were recorded in Gregg County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1980

Half the homes in Gregg County, Texas were built in 1980 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
53,883

Gregg County, Texas holds 53,883 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
60.3%

Owners occupy 60.3% of the occupied homes in Gregg County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Furnace Installation Rules on the Books for Gregg County, Texas5 codes, standards, and statutes

What Happens During a Furnace Installation in Gregg County

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Gregg County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Gregg County

Weather in this part of Texas puts real demands on heating and cooling equipment, and those demands shape what a furnace needs to handle over its working life. A system sized and installed for local conditions holds up where a generic job falls short.

Severe weather events by county — Gregg County
20100
2015201620172018201920202021202220232024
20

105 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.