Furnace Repair in Memphis

Serving Memphis and every community across Hall County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
View through a rain-streaked double-hung window with white trim onto a green leafy tree and a neighboring building with horizontal siding under a pale overcast sky.

A furnace repair call in Hall County starts with what the system has already been through. 172 severe weather events were recorded in Hall County, Texas between 2015 and 2024. Severe weather at that rate puts sustained demand on heating equipment, and the parts that carry the heaviest load, heat exchangers and ignition assemblies, are where a contractor looks first. A unit that has cycled hard through enough rough seasons will show wear in those components before anything else fails.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
An unfinished attic with wooden rafters, plywood decking and loose fiberglass insulation between joists, with a flexible foil-wrapped duct running along the floor toward two cardboard boxes at the far end.

Ductwork and wiring in a house this age were put in for the equipment of that era, and what replaced that equipment over the decades may have asked those systems to stretch. Half the homes in Hall County, Texas were built in 1959 or earlier (2020-2024 ACS 5-year). When a furnace from this stock opens up, the question a contractor has to answer is whether the part it needs still has a supply chain. Discontinued components mean longer lead times, substitute sourcing, or a repair scope that shifts once the unit is open and the part number is known.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

The Parts of a Furnace a Contractor Checks During Repair

Isometric line illustration of a cutaway single-story house with a shingled roof, showing an interior furnace connected to ductwork and a tall vertical flue pipe, plus simple furniture in the adjacent room.

The heat exchanger sits inside the furnace cabinet and is the piece a contractor looks at closely when a repair call comes in. Cracks or corrosion there affect both performance and safety. The burner assembly sits just below it and is where the flame originates, so a contractor checks it for buildup, misalignment, or ignition problems.

The blower motor and its fan wheel sit at the base of the cabinet and push conditioned air into the supply side of the duct system. The flue or vent pipe runs from the cabinet up and out of the house, and a contractor checks it because a blocked or separated flue sends exhaust the wrong direction. The thermostat, mounted on an interior wall, controls the whole sequence and is checked when the furnace fails to respond on schedule.

The drawing shows a typical furnace layout, and a licensed contractor determines which components apply to the specific system in your home.

Get matched in Hall County

Hall County, Texas, by the numbers

172

172 severe weather events were recorded in Hall County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1959

Half the homes in Hall County, Texas were built in 1959 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
1,739

Hall County, Texas holds 1,739 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
73.6%

Owners occupy 73.6% of the occupied homes in Hall County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Codes & Standards Covering Furnace Repair in Hall County, Texas5 sourced rules and standards

What HVAC Repair Looks Like in Hall County

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Hall County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Hall County

Extreme weather puts a measurable load on heating equipment, and Hall County's climate is the local baseline every furnace here runs against. That workload shapes when repairs happen and how hard the equipment has to work to keep up.

Severe weather events by county — Hall County
3020100
2015201620172018201920202021202220232024
24

172 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.