Furnace Repair in Floresville

Serving Floresville and every community across Wilson County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
Single-story brick house with a gray shingle roof, attached two-car garage with a beige door, and trimmed shrubs, seen during rain with a wet driveway in the foreground and overcast sky.

A furnace breaking down in Wilson County is rarely a weather story. 58 severe weather events were recorded in Wilson County, Texas between 2015 and 2024. At that rate, severe weather sits in the background of a system's life rather than grinding through it season after season. A contractor diagnosing a failed heat exchanger, a cracked igniter, or a seized blower motor here is most likely tracing back to deferred maintenance or a component that simply ran its years out. The weather record does not do the explaining, and a quote built around storm wear would be pointing at the wrong cause.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Interior of a garage with concrete block walls, a sectional overhead door, a step ladder and a filled sack, below a ceiling with exposed round and rectangular metal ductwork.

Half the homes in Wilson County, Texas were built in 2000 or earlier (2020-2024 ACS 5-year). A furnace that has been running in a house of that vintage has put real hours on its heat exchanger, igniter, and control board, and what a contractor finds when they open the unit is not predictable from the outside. Some components from that period are still manufactured; others require sourcing from secondary suppliers or are no longer available at all. That parts question shapes the repair scope before labor or anything else does.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

The Parts of a Furnace a Contractor Checks First

Isometric cutaway illustration of a single-story house showing interior rooms with a dark furnace unit, connected ductwork, a vertical flue pipe through the roof, and simple furniture, on a white background.

The heat exchanger sits at the core of the furnace cabinet and is the part a contractor looks at early in any repair call. Cracks or corrosion there let combustion gases into the airstream. The burner assembly sits just below it, and when ignition is sluggish or the flame pattern is uneven, that is where the diagnosis starts.

The blower motor and its wheel sit in the lower section of the cabinet and push conditioned air out through the supply side. The inducer motor pulls combustion gases toward the flue at the beginning of each cycle. The control board ties everything together, and when symptoms are scattered or hard to pin down, the board is what a contractor reads for fault codes.

The drawing shows the general layout of a furnace system, and a licensed contractor determines which components apply to your specific house and situation.

Find a contractor in Wilson County

Wilson County, Texas, by the numbers

58

58 severe weather events were recorded in Wilson County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
2000

Half the homes in Wilson County, Texas were built in 2000 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
19,480

Wilson County, Texas holds 19,480 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
84.7%

Owners occupy 84.7% of the occupied homes in Wilson County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Codes & Standards Covering Furnace Repair in Wilson County, Texas5 rules & standards

What Happens When a Contractor Comes Out

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing and Legal Requirements in Wilson County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Wilson County

Furnaces work harder and fail faster when local weather puts sustained demand on them. Knowing what this area has faced in recent years gives you a clearer picture of why repair needs here are not the same as they are somewhere else.

Severe weather events by county — Wilson County
20100
2015201620172018201920202021202220232024
15

58 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.