Furnace Installation in Abilene

Serving Abilene and every community across Taylor County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
A single-story red brick house with dark shutters, a shingled roof, an exterior air conditioning unit and a railed entry stoop, seen during rain with a wet concrete driveway in the foreground under an overcast sky.

A contractor quoting a furnace installation in Taylor County has to account for what the local climate routinely puts a heating system through. 225 severe weather events were recorded in Taylor County, Texas between 2015 and 2024. At that rate, severe weather is a standing condition of operating here, and it bears directly on how a furnace should be sized and how well every component of the install is sealed and supported. A unit that fits the catalog spec but not the local load will run harder to keep up, wearing its heat exchanger and controls faster than the rating assumes.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Interior of a concrete block garage with a closed sectional door, a stepladder and a filled sack on the floor, and large gray rectangular and round sheet metal ducts running along the exposed joist ceiling.

Ductwork laid down before modern forced-air furnaces became the norm was sized and routed for something different from what a new unit will push through it. Half the homes in Taylor County, Texas were built in 1978 or earlier (2020-2024 ACS 5-year). That gap is where a furnace installation either goes smoothly or picks up extra work: a contractor has to assess whether the existing duct system can carry the new equipment's airflow before anything else on the job is priced. The electrical side follows the same logic. What the house already contains determines the scope, and a contractor who skips that assessment is quoting blind.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Gets Installed With a New Furnace

Isometric line illustration of a cutaway single-story house showing interior rooms with furniture, ceiling ductwork, and an exterior furnace unit with a tall flue pipe.

The furnace itself sits in a utility closet, basement, or garage and is the unit a homeowner would see first. Inside it, the heat exchanger and burner assembly do the core work, with the blower motor pushing conditioned air out into the home. The flue pipe exits the top or rear and routes combustion gases out through the wall or roof.

The air handler cabinet houses the blower and the filter rack, which slots in at the return-air opening where air enters the system. A new thermostat mounts on an interior wall and gives the homeowner direct control over the furnace. The gas line connects at the valve on the furnace cabinet, and the condensate line, where present, runs to a nearby drain.

The drawing shows a representative layout, and a licensed contractor determines which components and configurations apply to your specific home.

Find a contractor in Taylor County

Taylor County, Texas, by the numbers

225

225 severe weather events were recorded in Taylor County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1978

Half the homes in Taylor County, Texas were built in 1978 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
62,198

Taylor County, Texas holds 62,198 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
60.5%

Owners occupy 60.5% of the occupied homes in Taylor County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Furnace Installation Rules for Taylor County, Texas5 codes, standards & licensing rules

What happens when a contractor comes out to do the work

Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Licensing Rules for HVAC Work in Taylor County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Taylor County

Weather puts a load on heating equipment that no spec sheet accounts for by itself. What happens outside in Taylor County shapes how hard a furnace works and how long it holds up, which is why local installation decisions start with local conditions.

Severe weather events by county — Taylor County
6040200
2015201620172018201920202021202220232024
55

225 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.